PREPARATION OF SURFACE

Before usage of Hendlex PPF&VINYL, ensure the surface is clean and dry by following these steps:

• Wash the car thoroughly, making sure there are no remaining substances that would interfere with the coating’s application (i. e. cleaning agents, dirt residue, solvents, etc.)
• Proceed to dry the surface entirely, including the spatial gaps between adjacent car parts.

Note: It is recommended to utilize HENDLEX Paint Prepare to guarantee a clean surface.

USAGE

1. Handle the applicator by the base. Place the application cloth on the soft part of the applicator, tightening it into cutouts on both sides.

*For smaller areas it is recommended to solely use the application cloth without using the applicator.

2. Open the bottle and wet the application cloth entirely. Throughout the process of coating, keep the application cloth wet by applying additional 5-6 drops.

3. Coat the surface evenly in criss-cross motion. Do not use circular movements for product coating. Coat one panel at the time. Try to coat from edge to edge to avoid coating layering marks. Coat the area of 1×1 m at the time. If temperature is higher than +24°C, coat smaller area. Make sure there are no uncovered spots left.

4. After applying coating, wait for:

– if temperature is lower than +24 °C – 2 minutes;

– if temperature is higher than +24 °C – 30 – 90 seconds;

– do not coat if temperature is more than +30 °C.

5. Polish the surface with the high quality microfiber cloth. Make sure there are no unpolished spots left.

6. Recommended coating curing period:

– if the temperature is higher than +22°C – 12 hours initial;

– if the temperature is +20°C – 24 hours initial.

Do not wash the car for at least 7 days. Depending on the environment temperature, the coating fully hardens in 7 days.